Yamaha RAPTOR YFM125RA Service Manual page 57

1. Spring
2. Adjusting screw
3. Washer
4. Adjusting nut
5. Rectifier/regulator
6. Clutch switch lead
7. Handlebar switch lead
8. Rectifier/regulator lead
9. Wire harness
10.Neutral switch lead
11.Drain hose
12.Clamp
13.Screw
14.Collar
15.Headlight
16.Spring nut
17.Headlight stay
18.Frame
19.Damper plate
A. The target of the screw protrusion is 12
mm (0.47 in).
B. Install the adjusting nut so that the spheri-
cal side faces to the front of the vehicle.
C. Insert the bottom hole of the rectifier/regu-
lator into the boss of the headlight stay.
D. To the front fender
E. Pass the rectifier/regulator lead outside of
the vehicle.
F. Pass the wire harness above the guide for
the damper plate.
G. Clamp on top of the frame bracket.
H. Pass the clamp through the damper plate
hole.
2-34
CABLE ROUTING