Operation; Login/Logout - Santec SanStore 4/8/16LMX User Manual

6. OPERATION

6.1. Login/Logout

You must log on to the DVR with valid password to operate the DVR. By factory default, it
comes with the login account "ADMIN" and the default password "000000".
Note:
If you are logging on for the first time, the system does not prompt you to change the default
password. Therefore, it's strongly recommended to change the "PASSWORD" when you
install the DVR (also see chapter 7.8.3).
Login:
1. On the front panel or the remote control, press the [POWER] button.
2. When the DVR is powered on, it will start to scan the DVR status.
3. The live viewing screen will appear after initialisation after about 50 sec. It can be
delayed if you have a defect HDD. In this case it will try to fix it for logical problems
but it will show you a warning message to indicate a physical problem.
4. On the front panel or the remote control, press the [LOGIN] button. Using the mouse,
click anywhere in the login dialog box.
5. The login icon
Logout:
On the front panel or the remote control, press the [LOGIN] button. Using the mouse, click
anywhere on the monitor. The virtual remote control will appear. The login icon will disappear
on starts bar, indication that you are logged off.
_________________________________________________________________________________
SanStore 4/8/16LMX / SanStore 4/8/16MMX / SanStore 8/16HMX
will be displayed on the status bar.
- 42 -
User manual