Ptz Event - Santec SanStore 4/8/16LMX User Manual

7.7.3 PTZ event

If an event is triggered by an alarm, motion or video loss, this DVR sends a preset command
to the PTZ camera. PTZ option must be enabled and a protocol must be assigned to the
camera channel.
1. Channel:
Select the desired PTZ camera.
2. Active:
Configure the PTZ action: none  go to  tour
3. Inactive:
Configure the command once an event has ended: none  go to  tour
4. Event edit:
Press [ENTER] to edit multiple events. The menus are displayed with options on the left-
hand column and settings in the right hand column. A cursor (highlighted menu) can be
moved using the direction buttons [
Note:
Do not set up motion detection on the PTZ camera for a PTZ event. The signal will be
looping. Use the [ - + ] buttons to change the values.
5. To save changes and exit the menu, press the [MENU] button.
To exit the menu without making changes, press the [CANCEL] button.
_________________________________________________________________________________
SanStore 4/8/16LMX / SanStore 4/8/16MMX / SanStore 8/16HMX
] on the remote control or the front panel.
- 78 -
User manual