Spot Monitor - Santec SanStore 4/8/16LMX User Manual

User manual
SanStore 4/8/16LMX / SanStore 4/8/16MMX / SanStore 8/16HMX

5.5. Spot monitor

In addition to the main monitor, attaching a spot monitor enables the user to monitor specific
channels independently from the main monitor. Press the [Spot] button on the remote control
and the DVR will change into SPOT mode.
Procedure:
[ - + ]:
Sport out display will change to SPOT 1-2-3-1-2-3
[Display]:
The [Display] button is used to set the spot sequence mode and the split mode.
[Spot/Cancel]:
Press the [SPOT button for 2 seconds or the [CANCEL] button to exit the main
monitor.
If there is no input signal, it will automatically change back to the main monitor after 5
seconds.
[#CH]:
Press the [SPOT] button on the remote control, then press the number button you
wish to watch as full screen.
_________________________________________________________________________________
Spot sequence mode:
Press the [SPOT] button first and then the [DISPLAY] button
for 2 seconds to toggle automatically between the cameras.
The interval of the sequence can be defined by the sequence
setting.
Spot split mode:
Press the [SPOT] button first and then the [DISPLAY] button
to select the split mode. Split mode can be defined in the
display menu.
- 41 -