Santec SanStore 4/8/16LMX User Manual page 48

Tune:
ITEM DEFAULT
BRIGHTNESS
CONTRAST
COLOUR
SATURATION
PTZ setup:
PTZ device are connected to the RS-422/485 ports located on the back of the unit.
Multiple PTZ cameras are connected by daisy-chaining the camera connection.
This DVR allows you to address and control multiple PTZ cameras individually.
Press [Enter] to configure the PTZ setup. The menus are displayed with options on the left-
hand column and settings in the right hand column.
a. ID:
Configure the appropriate model and then enter the corresponding Baud rate and
camera PTZ ID (address).
b. Tour group:
Preset tours allow a camera to move though a programmed sequence of PTZ
presets.
Note:
The programmed tours are saved in the DVR and not in the PTZ camera.
The presets used for a tour are copied onto the PTZ camera, i.e. presets are stored in
the camera.
_________________________________________________________________________________
The brightness of each camera can be adjusted by pressing the
50
[-,+] buttons.
The contrast of each camera can be adjusted by pressing the
50
[-,+] buttons.
The colour of each camera can be adjusted by pressing the [-,+]
50
buttons.
The saturation of each camera can be adjusted by pressing the
50
[-,+] buttons.
SanStore 4/8/16LMX / SanStore 4/8/16MMX / SanStore 8/16HMX
ADJUSTMENT
- 48 -
User manual