Xerox DocuColor 12 System Administration Manual page 40

3
Review the current settings for each tray. Use the
up and down arrows to highlight the desired paper
1
tray and touch the Change Settings button to
display the detail screen for the tray. A sample
detail screen for Trays 2, 3, and 4 is illustrated in
Figure 8.
NOTE:
•
2
•
4
Touch the button for the setting that best
describes the paper type for the tray.
3
5
Touch Save to display the Paper Type screen.
6
If necessary, repeat steps 3 through 5 for another
paper tray.
7
Touch Close to display the Tray Management
screen.
4
8
Touch Close to display the Tools screen.
5
6
7
TOOLS MODE
You can not run heavyweight paper from
Paper Tray 1. The only option on the Tray 1
detail screen is Normal.
The Auto Tray Setup - Switching option, set
through Auto Paper Select, must be disabled
before you can select the Heavyweight option
for Trays 2, 3, or 4.
Figure 8: Sample Tray detail screen
3–6 DOCUCOLOR 12 SYSTEM ADMINISTRATION GUIDE