Kerberos Configuration Section - Symbol WS5000 Series System Reference Manual

Table 3.3 General Network Configuration and Standby Management (Continued)
Option Value
Eth1DHCP
Eth2DHCP
Gateway
HostnamePrimary
HostnameStandby
Eth1PrimaryIP
Eth2PrimaryIP
Eth1StandbyIP
Eth2StandbyIP
StandbyMgt

3.2.4 Kerberos Configuration Section

The Wireless Switch features a built-in Kerberos KDC (Key Distribution Center) for authentication services, a
site may require settings for configuring Kerberos functionality. The settings in the command file for
configuring the KDC include Primary or Slave status, hostname, IP address, realm and domain. When
applicable up to three NTP (Network Time Protocol) servers can be specified. A list of all available Kerberos
actions is included in the command file.
Table 3.4 Kerberos Configuration Section
Option Value
NTPServer1 <NTP xxx.xxx.xx.xx>
<NTP xxx.xxx.xx.xx>
NTPServer2
NTPServer3 <NTP xxx.xxx.xx.xx>
Configuring the WS 5000 Series Switch Auto-
Notes
Indicates whether DHCP is on/off for Ethernet port 1.
Indicates whether DHCP is on/off for Ethernet port 2.
If DHCP is on for an interface, all IP settings provided in the command file will
be ignored and the interface will be configured as a DHCP client.
Note DHCP can only be enabled on a single interface
at a time.
Default gateway. There should only be one value since the switch currently
does not allow gateway settings per interface. If this configuration is not
specified, the DHCP settings apply.
Hostname of Primary switch.
Hostname of Standby switch.
IP address of Primary switch.
IP address of Primary switch.
IP address of Standby switch.
IP address of Standby switch.
If these IP addresses are not specified in the command file, the DHCP settings
are kept. When an image upgrade is performed, it will not change the existing
Ethernet configuration.
Indicates whether Standby Management is on/off (enabled/disabled).
If enabled, the installation software queries the database for the number of
licenses. If the switch is able to acquire a license, it may become a Primary
switch. If no license is available, it can only be considered as a Standby switch.
Notes
NTP server IP address (for the on-board KDC server). The
primary and standby switches need to be defined with the
same NTP service host to insure that the time source is
consistent.
Second alternate NTP server IP address .
Third alternate NTP server IP address or name.
3-5