Usb Ibm Surepos; Ibm Secondary Interface - Honeywell Voyager 1202G-BF User Manual

Option
Symbologies

USB IBM SurePos

Scan one of the following "Plug and Play" codes to program the scanner for an IBM SurePos (USB handheld scanner) or
IBM SurePos (USB tabletop scanner) interface.
Note: After scanning one of these codes, you must power cycle the cash register.
USB IBM SurePos
(USB Handheld Scanner)
Interface
Each bar code above also programs the following suffixes for each symbology:
Symbology
EAN 8
EAN 13
UPC A
UPC E

IBM Secondary Interface

On some older IBM cash registers, it may be necessary to disable the secondary or management interface. In particular, it
has been found necessary on IBM registers using the 4690 V2R4 operating system. The following bar codes are used for
this purpose. Default = Enable Secondary Interface.
*Enable Secondary Interface
Setting
Enable UPC-A with check digit and number system
Enable UPC-E0 with check digit
Enable EAN/JAN-8 with check digit
Enable EAN/JAN-13 with check digit
Enable Code 128
Enable Code 39
Enable OPOS with automatic disable off
OPOS Mode
Suffix Symbology
0C Code 39
16 Interleaved 2 of 5
0D Code 128
0A Code 39
USB IBM SurePos
(USB Tabletop Scanner)
Interface
Suffix
00 0A 0B
00 0D 0B
00 18 0B
00 0A 0B
2 - 3