Alarm Duration; Scanner Power Time-Out Timer; Rangegate - Honeywell Voyager 1202G-BF User Manual

Alarm Duration

To set the the length of time you want the Out-of-Range alarm to sound, scan the following bar code and then set the time-
out duration (from 0-3000 seconds) by scanning digits on the
Save. Default = 1 sec.

Scanner Power Time-Out Timer

Note: Scanner Power Time-out Timer only applies to cordless systems. It does not apply to corded scanners.
When there is no activity within a specified time period, the scanner enters low power mode. Scan the appropriate scanner
power time-out bar code to change the time-out duration (in seconds).
If the scanner is not activated during the timer interval, the scanner goes into power down mode. Whenever the scanner is acti-
vated, the timer is reset. If
mode. Default = 3600 seconds.
Timer Off
400 seconds
* 3600 seconds
Note: When the scanner is in power down mode, press the scanner's button to power the unit back up. There will be a set of
power up beeps and a delay of up to a few seconds for the radio to join. The scanner will then be ready to use.

RangeGate

If you need RangeGate functionality, the scanner can be programmed for
equivalent capabilities.
3 - 10
Scanner Alarm Duration
Scanning While in Base Cradle
Programming Chart
(page 3-6) is disabled, the scanner will still go into power down
Automatic Batch Mode
inside the back cover, then scanning
200 seconds
900 seconds
7200 seconds
(page 3-11), which offers