Gs1 Databar Expanded; Trioptic Code - Honeywell Voyager 1202G-BF User Manual

GS1 DataBar Expanded

GS1 DataBar Expanded On/Off
* On
GS1 DataBar Expanded Redundancy
If you are encountering errors when reading GS1 DataBar Expanded bar codes, you may want to adjust the redundancy
count. Redundancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number
of errors. Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redun-
dancy, scan the GS1 DataBar Expanded Redundancy bar code below, then scan a redundancy count between 0 and 10
on the Programming Chart
GS1 DataBar Expanded Message Length
Scan the bar codes below to change the message length. Refer to
information. Minimum and Maximum lengths = 1-80. Minimum Default = 3, Maximum Default = 80.
Minimum Message Length

Trioptic Code

Trioptic Code is used for labeling magnetic storage media.
On
8 - 48
< Default All GS1 DataBar Expanded Settings >
inside the back cover of this manual. Then scan the
GS1 DataBar Expanded
Redundancy
Save bar code. Default = 0.
Message Length Description
Off
(page 8-1) for additional
Maximum Message Length