Table of Contents
Advertisement
Chapter 8 VLAN
8.3.2 Configure a Static VLAN
Use this screen to configure and view 802.1Q VLAN parameters for the ONU. See
page 79
for more information on static VLAN. To configure a static VLAN, click Static
VLAN in the VLAN Status screen to display the screen as shown next.
Figure 33 Advanced Application > VLAN > Static VLAN
The following table describes the related labels in this screen.
Table 16 Advanced Application > VLAN > Static VLAN
LABEL
ACTIVE
Name
VLAN Group ID
Port
*
Control
84
DESCRIPTION
Select this check box to activate the VLAN settings.
Enter a descriptive name for the VLAN group for identification purposes. This name
consists of up to 64 printable characters; spaces are allowed.
Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.
The port number identifies the port you are configuring.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select Normal for the port to dynamically join this VLAN group using GVRP. This is
the default selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
Section on
ONU User's Guide
Advertisement
Table of Contents
