Table of Contents
Advertisement
Chapter 20 Authentication & Accounting
Table 47 Advanced Application > Auth and Acct > RADIUS Server Setup (continued)
LABEL
IP Address
UDP Port
Shared Secret
Delete
Apply
Cancel
Accounting
Server
Timeout
Index
IP Address
UDP Port
Shared Secret
Delete
Apply
Cancel
148
DESCRIPTION
Enter the IP address of an external RADIUS server in dotted decimal notation.
The default port of a RADIUS server for authentication is 1812. You need not
change this value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared
between the external RADIUS server and the ONU. This key is not sent over the
network. This key must be the same on the external RADIUS server and the ONU.
Check this box if you want to remove an existing RADIUS server entry from the
ONU. This entry is deleted when you click Apply.
Click Apply to save your changes to the ONU's run-time memory. The ONU loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section to configure your RADIUS accounting server settings.
Specify the amount of time in seconds that the ONU waits for an accounting
request response from the RADIUS accounting server.
This is a read-only number representing a RADIUS accounting server entry.
Enter the IP address of an external RADIUS accounting server in dotted decimal
notation.
The default port of a RADIUS accounting server for accounting is 1813. You need
not change this value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared
between the external RADIUS accounting server and the ONU. This key is not sent
over the network. This key must be the same on the external RADIUS accounting
server and the ONU.
Check this box if you want to remove an existing RADIUS accounting server entry
from the ONU. This entry is deleted when you click Apply.
Click Apply to save your changes to the ONU's run-time memory. The ONU loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
ONU User's Guide
Advertisement
Table of Contents
