Table of Contents
Advertisement
Chapter 15 Link Aggregation
The following table describes the labels in this screen.
Table 33 Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL
Link Aggregation Setting
Group ID
Active
Port
Group
Apply
Cancel
15.4 Link Aggregation Control Protocol
Click in the Advanced Application > Link Aggregation > Link Aggregation Setting >
LACP to display the screen shown next. See
dynamic link aggregation.
Figure 53 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
118
DESCRIPTION
The field identifies the link aggregation group, that is, one logical link containing
multiple ports.
Select this option to activate a trunk group.
This field displays the port number.
Select the trunk group to which a port belongs.
Click Apply to save your changes to the ONU's run-time memory. The ONU loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
Section on page 116
for more information on
ONU User's Guide
Advertisement
Table of Contents
