Chapter 15 Link Aggregation
15.5 Technical Reference
The following section contains additional technical information about the ONU features
described in this chapter.
Static Trunking Example
This example shows you how to create a static port trunk group for ports 2-5.
1 Make your physical connections - make sure that the ports that you want to belong to
the trunk group are connected to the same destination. The following figure shows ports
2-5 on switch A connected to switch B.
Figure 54 Trunking Example - Physical Connections
2 Configure static trunking - Click Advanced Application > Link Aggregation > Link
Aggregation Setting. In this screen activate trunking group T1 and select the ports that
should belong to this group as shown in the figure below. Click Apply when you are
done.
Figure 55 Trunking Example - Configuration Screen
Your trunk group 1 (T1) configuration is now complete; you do not need to go to any
additional screens.
120
A
B
ONU User's Guide