Infinova VH110-A2 Series Instruction Manual page 8

Authentication: Enable or disable authentication function. This function

should be set according to authentication requirements of mail server.
User name: Sender's name, it can be set according user's needs.

Password: Set sender's password.

Note: there is no limit for Sender's name and password settings.
After setting, click "Set" Save to take effect.
If user selects "mail" in "Alarm Settings" interface, system will send mails
according to SMTP settings.
4.3.4 HTTPS Settings
Figure 4-14 HTTPS Settings
VH110-A2 series camera supports HTTPS protocol. You can import the CA
certificate in the interface.
4.3.5 802.1X Settings
Figure 4-15 802.1X Settings
VH110-A2 series camera supports multicast function. In the IGMP interface,
users can select the stream type and set the state, multicast IP address and RTP
port.
4.3.8 SIP Settings
Figure 4-18 SIP Settings
SIP Server: to configure SIP server for device;
SIP Server IP: the IP address of SIP server;
Port: the port number of SIP server;
Server ID: the ID of SIP server;
Device ID: the device ID used for registration with SIP server;
Alarm ID: the ID registered for device alarm;
Register Interval: the interval for re-registration of device in seconds;
Heat Beat Interval: the interval to send heartbeat information by the device in
25
27
VH110-A2 series camera supports 802.1X protocol. You have to enable 802.1X
authentication when needed. Then, select an EAP method and enter the user
name and password.
4.3.6 QOS Settings
Figure 4-16 QOS Settings
There are 4 network Qos modes to be selected:
(1) Normal Service
(2) Max Reliability
(3) Max Throughput
(4) Min Delay
Recommend: Normal Service.
4.3.7 IGMP Settings
Figure 4-17 IGMP Settings
seconds;
After configuration completed, click Save and the device sends a registration
request to the server.
Position Information: the mounting information or instruction for device.
Longitude: the longitude of mounting position, as precise to two places of
decimal;
Latitude: the latitude of mounting position, as precise to two places of decimal.
4.3.9 DDNS Settings
Figure 4-19 DDNS Settings
Dynamic Domain Name System (DDNS) synchronizes the host name and
dynamic IP address continuously. Users don't have to memorize the dynamic
IP address, but enter the dynamic domain name to connect the IP camera.
DDNS needs a PC with fixed IP address on the Internet to run the dynamic
domain name server.
Operation: select DDNS type in Enable option, enter the IP address of the
DDNS server into the address bar, configure domain name, user name, and
password and update time and then save the settings. Open the IE browser, and
enter the domain name to go to the query page of the device.
26
28