Table of Contents
Advertisement
1.6 Notice
1. Firstly perform network settings after login. The gateway IP address should
be set as that of the connected to the network camera.
2. The IP address is not allowed to conflict with that of other devices; otherwise,
you cannot visit the camera.
3. If the purchased IP camera utilizes PoE power supply, please connect
equipments according to the parameter of the Power Supply Switcher strictly.
Furthermore, practical test of maximum network cable length for the Power
Supply Switcher must be performed, so as to avoid the camera failure caused
by insufficient power supply of the Power Supply Switcher, or to avoid the
destruction of Switcher.
1
Audio In
3
Audio Input GND
5
Alarm In 1
7
Alarm In 2
9
RS485TX-
Notes: The analog video is disabled when the MJPEG video stream is
enabled. To enable the analog video, please disable the MJPEG video
stream.
On the left of camera body (face the lens to view), there is an IRIS connector.
The pin definition is as follows:
Note: The camera supports DC DRIVE.
Pin
3
1
1
2
3
2
4
4
⑥ Reset Button: If press and hold the button for more than5s, camera's
parameters will restore the default values.
2.3 Dimensions
(Unit: inch, in the parentheses is mm)
5
2
Audio Out
4
Audio Input GND
6
Alarm Out
8
Alarm Out Com
10
RS485TX+
DC DRIVE
DAMP-
DAMP+
DRIVE+
DRIVE-
Figure 2-2
7
CHAPTER II INSTALLATION AND PORT INTRODUCTION
2.1 Installation Precautions
Do not drop the camera or subject it to strong knock.
Do not point the camera lens toward the sun or other strong light.
Do not install the camera in environment with temperature beyond the
acceptable range (from -20°C to 60°C), or with high humidity, direct
rainfall, frequent vibrations and shocks.
Add with auxiliary illumination device in case of low illumination to avoid
poor image quality.
2.2 Back Panel and Control Parts
3
4
TF
~
1
2
24VAC
-
+
12VDC
1 AUDIO IN
2
AUDIO OUT
3
AUDIO IN GND
4
AUDIO OUT GND
5
6
ALARM OUT
ALARM IN 1
7
ALARM IN 2
8
ALARM GND
9
RX485 TX-
10
RX485 TX+
NETWORK
802.3 af PoE
2
Figure 2-1 Back View
①
Input/
Output Port
②
Network Port (used for PoE power supply)
③Power Input Port
④TF card slot
⑤Analog Video Output
Reset
⑥
⑦Power LED Indicator
2.4 Installation of Camera
When mounting the camera on fixer, pan/tilt, etc., use 1/4-20UNC screw and
the camera-mounting screw hole located on the camera-mounting bracket. The
camera-mounting bracket can be mounted on the top or at the bottom of the
camera. See the figure below:
Figure 2-4 Camera-mounting brackets
5
1
3
5
7
9
RESET
6
STATUS
7
2
4
6
8
10
1
6
Figure 2-3
8
Advertisement
Table of Contents
