Table of Contents
Advertisement
Note:
When installing the unit on a bracket, make sure to choose the suitable
position that can support the weight of the camera and the bracket in years
and fix them properly.
Exercise maximum caution when installing the unit to the wall or ceiling.
You should not engage in the installation work yourself. Ask a professional
to do the job, since the fall of the unit can result in injuries and accidents.
When installing the unit on a fixer, turn table, etc., make sure to install it
firmly using a mounting hole provided on the mounting bracket to prevent
fall.
As a failsafe against falling, attach the unit by chain, wire cable or other
safety restraint to an appropriate anchor point.
If the installation fails, check whether there is video viewed through other IE
window or page. You should close the video or the IE window directly.
If it successes, click refresh, you can view the live video.
Method 2:
The prompt message as below will come out in the page after a successful
login. Right click "Add-on Disabled" and select "Run Add-on".
Then the prompt of security warning will pop up to remind the user to install
InfiPlayerAX
control. Click "Install".
After InfiPlayerAX control is installed, you can view the live video. If it pops
up reboot prompt, please cancel reboot. Then close all the IE window and
install InfiPlayerAX control once again. The live video will display as below:
9
Figure 3-1
Figure 3-2
Figure 3-3
11
CHAPTER III IE BROWSER SETTINGS
When view the video, the user need to adjust the IE browser of the monitor or
other video devices, and set proper system function based on the following
instructions:
Support IE browser version: Internet Explorer 6.0 or above;
Must install
InfiPlayerAX
control and equip with Directx 9.0c.
3.1 Equipment Connection
The VH110-A2 series HD 2MP low light IP cameras can be directly connected
to a computer, or connected to a network.
Note: Check whether the connection is tight or not before power-on.
3.2 Software Installation
The installation procedures of VH110-A2 series HD 2MP low light IP camera
image software are listed as follows:
(1) Login
First, start IE browser and enter IP address. Enter user name and password in
the pop-up login interface.
The default IP address is http://192.168.1.100; the default subnet mask is
255.255.255.0 and the default gateway IP address is 192.168.1.254. For normal
access, correctly set local IP parameters before system login.
Do log in the system with the default super user for the first time to run the
software. The default Super User is admin (password: admin).
(2) Install control
There are two ways to install control.
Method 1:
The prompt message as below will come out in live view window after a
successful login. Click the link to run, or store the exe file, then run it.
Note:
If InfiPlayerAX control installation falls, the live video won't display. Then,
you should change the IE security level.
1. Select "Tool" in the menu bar, and then select "Internet Options" from the
drop-down menu.
2. Select "Security" in the pop-up Internet options.
3. Click "Internet" icon and then click "Custom Level".
4. Select "Enable" or "Prompt" in the options of "Download unsigned ActiveX
controls".
5. Click
"Internet",
Privacy in the
clear "Block pop-ups", then redraw the screen
and install control as per the prompt. The live video will display.
By now, the IE browser setting for image viewing comes to an end.
10
Figure 3-4
12
Advertisement
Table of Contents
