Table of Contents
Advertisement
When the camera is working with Pan/Tilt, you can set camera address, baud
rate and protocol in the interface. You can also set wiper, Pan/Tilt working
mode, preset, auto pan, pattern, home return, and etc.
4.7 Alarm Settings
Click "Alarm" in the navigation bar to display the following Alarm Settings
interface:
Figure 4-37 Alarm Settings
Alarm Configuration
I/O in 1, I/O in 2: Settable 2-channel alarm inputs.
Each alarm input has 2 modes: Grounded Circuit or Open Circuit.
Alarm out Contact: used to set sending way of alarm.
Local Contact: I/O out is triggered by I/O alarm in, motion detection alarm,
shelter alarm, TF card out, network link down or IP address conflict. Default:
download the recorded videos.
4.8.1 Record Settings
Figure 4-38 Record Settings
: Select the type of videos to record, major stream or minor
type
Recording video
stream.
: Overwrite or Stop. Overwrite means newly recorded videos
full
TF card when
automatically overwrite the previous videos when the TF card is full; Stop means
recording stops when the TF card is full.
Recording mode: Alarm triggered, Always, Close. If alarm Triggered is selected,
also with TF card selected under alarm out contact in the alarm interface (refer to
4.7), recording is automatically triggered when alarm occurs.
You can view the total size, used space and state of TF card and also format it.
To remove TF card when it is being used, please click
45
"Reject"
.
47
Local Contact.
Net Contact: I/O out is controlled by the surveillance management software.
Note: This function needs to be supported by digital video surveillance
management software like V2216. If Net Contact is selected, users have to set
Alarm Server IP the same as the IP address of V2216-CMS server. After
related setting to V2216 finished, users can remotely control the relay via
V2216 software. For detailed information, please refer to V2216 manual.
Alarm Server IP: used to set the IP address of alarm server. If alarm occurs, it
will inform the alarm server.
Alarm out Contact
Users can set the relevant alarm response ways for I/O alarm in, motion
detection alarm, shelter alarm, TF card out, network link down or IP address
conflict: Alarm out 1 (if Net Contact is selected, Alarm output 1 on the web
page is unavailable), TF card, Mail, FTP or Audio. After setting completed,
click "Save" button to take effect.
Note: when "FTP" or "Mail" is selected, you need to set FTP or SMTP
parameters in Network Settings, refer to Section 4.3.2 or Section 4.3.3 for
details.
Alarm Schedule
VH110-A2 series camera can set the effective alarm schedule. Select the alarm
period (if Sunday is selected, alarm will be enabled during the set period of
each Sunday; if every day is selected, alarm will be enabled during the set
period of everyday), and then, set the time period. Enter the start time and end
time in the 24-hour format. The end time must be larger than the start time.
4.8 Record Management
VH110-A2 series camera supports storage with TF card. In the Record
Management interface, you can set the recording parameters, replay and
4.8.2 Replay
Figure 4-39 Replaying
Video Search: set the start and end time, and then click the search button. All
videos recorded during this period of time will display in the list.
Figure 4-40 Searching Videos
46
48
Advertisement
Table of Contents
