Camera Settings - Infinova VH110-A2 Series Instruction Manual

4.3.10 UPnP Settings
Create mapping between private network and the Internet via UPNP protocol.
Select UpnP option and enter the configuration page. The added mapping list
appears on the page.
Figure 4-20 UPnP Settings
In "Operation" column, means to delete;
information.
Click Add button to add the mapping.
Figure 4-21

4.4 Camera Settings

Click "Camera" in the navigation bar to enter the interface shown as below:
Enable or disable vertical/horizontal mirror, backlight compensation or WDR.
4.4.2 Exposure Settings
Figure 4-23 Exposure Settings
Exposure set, scene, AGC, auto aperture, ICR control, ICR switch time, shutter
speed and manual AGC can also be set in this interface.
Exposure Set: Manual, Scene and Shutter priority. In the Scene mode, indoor or
outdoor can be selected and AGC can be set (8X, 16X, 32X, 48X, 64X
optional); if set to manual mode, shutter speed can be set from
and manual AGC can be set to
nonadjustable; if set to shutter priority mode, the shutter speed and AGC can be
set.
Auto Aperture: to enable or disable auto iris.
ICR Control: Auto mode, Night, Day, and IO input 1 or IO input 2. In Auto
mode, the camera can automatically control the day/night switching; in Day
means to edit user
29
1/30s to 1/8000s
, yet the scene and AGC are
1X to 64X
31
Figure 4-22 Basic Settings
5 option tabs are included in the camera settings page: Basic set, Exposure,
Effect set, White balance, and Reset.
4.4.1 Basic Settings
You can set the following parameters:
Anti-flicker frequency: 50Hz or 60Hz.
AO: It automatically changes with the flicker frequency. (Notes: analog videos
are shut off after MJPEG stream is enabled. To enable analog videos, please
disable MJPEG stream.)
mode, videos are in color mode; in Night mode, videos are in black/white mode;
in IO input 1 or 2 mode, ICR is controlled by external signals.
ICR switch: set ICR switch time.5s, 10s, 15s, 20s, 25s, 30s optional.
4.4.3 Effect Settings
In the Effect Settings interface, users can adjust the brightness, sharpness, hue,
contrast; saturation and 3D Denoise in two ways: General or Mode, as shown in
the figure below:
Figure 4-24 Effect Set -General
Drag the sliding block to adjust the brightness, sharpness, hue, contrast,
saturation and 3D denoise parameters.
30
32