System - Infinova VH110-A2 Series Instruction Manual

White Balance, Reset), Audio & Video Settings, Alarm Settings, Record setting,
Account Settings (Add/Delete User, Change Password), Log, etc.
Note: The following instructions are used for the super user.

4.2 System

Click the navigation bar [System] and it displays the following three option tabs:
System, Time and Advanced, as shown in Figure 4-4.
4.2.1 System Information
The initial interface of System Settings displays related system information,
such as basic system information, network settings, NTP settings, alarm settings,
H.264/MJPEG video settings, etc.
4.2.2 Time Settings
Figure 4-5 "Time" Settings
Time Zone Settings
Time Zone: Select the desired time zone in the scroll box, and then click "Save"
to save it.
There are 33 time zones for your selection:
Confirm the requirement submitted by user, we will provide the latest software
for download, and help user to update the VH110-A2 series camera.
Follow the steps below to update software:
Click "Browse" button on the interface and the file selection dialog box will
pop up.
Select update file, and press "Open" button. The selected update file will be
displayed in the Software Update box.
After that, click "Submit" button to update software, the following information
will appear:
17
Figure 4-7
Figure 4-8
19
If Daylight Saving Time is applied in your region, please turn on Daylight
saving time.
After completed, please click the button "Save".
NTP Settings
Set the NTP server's IP address, synchronization interval, etc.
After completed, please click the button "Save".
Sync now
There are two sync modes: local sync and NTP sync.
Local Sync means the system time is consistent with that of local PC. In the
NTP Sync mode, the system will automatically adjust time to the same as that
of NTP Server.
4.2.3 Advanced Settings
Figure 4-6 "Advanced" Settings
Software Update
Free software update is provided for VH110-A2 series camera, and this update
service can reduce system maintenance budget.
Click "Yes" button, run the program to finish the update.
The response time is due to the program type. You may wait a long time for
some program. Do not power off during the update process. Power-off will
make update fail, even damage the original program or disrupt update again.
After successful update, it needs to reboot the system. There is time prompt in
the web page during reboot. After reboot, it will skip to new web page to run
new program.
Note: Available only for the super user.
Factory Settings
VH110-A2 series camera provides online reset function, which greatly
facilitates reset adjustment.
Select "Keep current IP unchanged", click "Reset" button and the system will
pop up a message as below:
Click "OK", all the parameters (excluding IP address) will be reset to the
factory default settings.
If "Keep current IP unchanged" is unselected, the IP address will be reset to the
factory default settings.
There is time prompt in the web page during reset. After reset, it will skip to
new web page.
If current IP unchanged, you can access web page directly. If IP address resets
to 192.168.1.100, you can't access web page. Then, you have to set PC's IP
address to 192.168.1 section, such as 192.168.1.25. After that, access web page
to change camera's IP address and save, PC's IP address will restore to the
18
Figure 4-9
20