Led Board - HP ENVY m6 Maintenance And Service Manual

LED board

Description
LED board (includes cable)
Before removing the LED board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the hard drive (see
7. Remove the right speaker
Remove the LED board:
1. Disconnect the LED board cable (1) from the system board.
2. Pull the ribbon cable up to disengage the adhesive securing it to the computer (2).
3. Remove the two Phillips PM2.5×3.0 screws (3) that secure the LED board to the computer.
4. Remove the LED board (4) from the computer while routing the LED board cable under the keyboard
cable.
Reverse this procedure to install the LED board.
Bottom cover on page
Battery on page 44).
Hard drive on page 46).
(Speakers (front) on page
29).
48).
Component replacement procedures
Spare part number
812696-001
51