Hard Drive Led Board - HP ProBook 11 G1 Maintenance And Service Manual

3. Remove the two Phillips PM2.0×3.7 broad head screws (2) that secure the power button board to
the keyboard/top cover.
4. Remove the power button board (3).
Reverse this procedure to install the power button board.

Hard drive LED board

Description
Hard drive LED board
NOTE: The hard drive LED board spare part kit does not include the hard drive LED board cable. The
hard drive LED board cable is included in the Cable Kit, spare part number 809856-001.
Before removing the hard drive LED board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Bottom cover (see
b. Hard drive (see
c. Keyboard/top cover (see
Remove the hard drive LED board:
54 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 26), and then remove the following components:
Bottom cover on page
Hard drive on page 30)
Keyboard/top cover on page
28)
50)
Spare part number
809864-001