Display Assembly - Touch Screen - HP ENVY m6 Maintenance And Service Manual

Display assembly – touch screen
To remove the display assembly and access the display assembly subcomponents, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the hard drive (see
7. Remove the speakers (see
8. Remove the system board (see
Remove the display assembly:
1. Open the computer and position the computer with the display hanging over the edge of a tablet.
CAUTION:
sustaining damage.
2. Remove the six Phillips PM2.5×4.0 screws (1) (three on each hinge) that secure the display assembly to
the computer.
3. Remove the three broadhead Phillips PM2.5×2.5 screws (2) (two on the right hinge, one of the left
hinge) that secure the display assembly to the computer.
4. Separate the display from the computer (3).
If it is necessary to replace any of the display assembly subcomponents:
1. To remove the display rear cover:
The display hinge covers are available using spare part number 812699-001.
58 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page
Hard drive on page
Speakers (front) on page
System board on page
Be sure to support the display as you remove the screws to avoid the display falling and
29).
44).
46).
48).
55).