Led Board - HP ZBook Studio G 315-ap000 – 15ap099 Maintenance And Service Manual

LED board

Description
LED board
Before removing the LED board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see
5. Remove the bottom cover (see
6. Remove the battery (see
Remove the LED board:
1. Remove the tape from atop the cable (1).
2. Disconnect the cable from the system board (2).
3. Remove the two Phillips PM2.0×2.0 broadhead screws (3) that secure the LED board to the computer.
4. Remove the LED board (4).
Reverse this procedure to install the LED board.
Service door on page
Bottom cover on page
Battery on page 30).
28).
29).
Component replacement procedures
Spare part number
840957-001
43