Adjusting The Starter Cable - Yamaha 2004 Rhino 660 YXR660FAS Service Manual

ADJUSTING THE THROTTLE CABLE/

ADJUSTING THE STARTER CABLE

3 - 8
5. Remove:
• throttle valve cover
6. Install:
• console
• passenger seat
• driver seat
ADJUSTING THE STARTER CABLE
1. Remove:
• driver seat
• passenger seat
• console
Refer to "SEATS, ENCLOSURE, HOOD
AND CARGO BED" in chapter 8.
2. Adjust:
• starter cable
M MMM M MMM M M MMM M M MMM M
a. Disconnect the starter cable 1 from the
carburetor body.
NOTE:
Do not remove the starter plunger 2 from the
starter cable.
b. Measure the starter plunger stroke distance
a of the starter (choke) knob 3 fully close
to fully open position. If the distance is out
of specification adjust it as described below.
Starter plunger stroke distance
13 mm (0.51 in)
È Fully closed position
É Fully open position
c. Pull back the boot 4.
d. Loosen the locknut 5.
e. Turn the adjuster 6 in or out until the cor-
rect distance is obtained.
Turning in Distance increased.
Turning out Distance decreased.
f. Tighten the locknut 5.
g. Push in the boot 4.
h. Connect the starter cable to the carburetor.
L LLL L LLL L L LLL L L LLL L
CHK
ADJ
M MMM M M MMM M MMM
L LLL L L LLL L LLL