Checking The V-Belt - Yamaha 2004 Rhino 660 YXR660FAS Service Manual

CHECKING THE V-BELT

2. Check:
• V-belt 1
Cracks/wear/scaling/chipping → Replace.
Oil/grease → Check primary sheave and
secondary sheave.
3. Measure:
• V-belt width 2
Out of specification → Replace.
V-belt width
33.2 mm (1.31 in)
<Limit:> 29.9 mm (1.18 in)
4. Replace:
• V-belt
M MMM M MMM M M MMM
a. Install the bolts 1 (90101-06016) into the
secondary fixed sheave hold.
NOTE:
Tightening the bolts 1 will push the secondary
sliding sheave away, causing the gap between
the secondary fixed and sliding sheaves to
widen.
b. Remove the V-belt 1 from the primary
sheave and secondary sheave.
c. Install the V-belt.
NOTE:
Install the V-belt so that its arrow faces the
direction shown in the illustration.
d. Remove the bolts.
L LLL L LLL L L LLL
3 - 24
CHK
ADJ
M M MMM M M MMM M M MMM M
L L LLL L L LLL L L LLL L
MMM
LLL