Installing The Shift Levers - Yamaha 2004 Rhino 660 YXR660FAS Service Manual

È
1
1
É
2
1
1
3. Fit the left crankcase onto the right case.
Tap lightly on the case with a soft hammer.
CAUTION:
Before installing and torquing the crank-
case holding bolts, be sure to check
whether the transmission is functioning
properly by manually rotating the shift
drum in both directions.
4. Tighten:
1
• crankcase bolts 1, 2
(follow the proper tightening sequence)
• crankcase bolts 3
1
(follow the proper tightening sequence)
È Left crankcase
1
É Right crankcase
NOTE:
• Tighten the bolts in stages, using a criss-
cross pattern.
4
• Apply sealant (Quick Gasket
1
thread of the bolt 2 shown in the illustration.
3
1
5. Apply:
• 4-stroke engine oil
(to the crank pin, bearing and oil delivery
hole)
6. Check:
• crankshaft and transmission operation
Unsmooth operation → Repair.

INSTALLING THE SHIFT LEVERS

1. Install:
• shift lever 2 assembly 1
• shift lever 1 2
NOTE:
When installing the shift lever 1, align the
punch mark a on the shift lever 1 with the
punch marks b on the shift lever 2.
4 - 72
ENG
CRANKCASE
10 Nm (1.0 m · kg, 7.2 ft · lb)
26 Nm (2.6 m · kg, 19 ft · lb)
Sealant (Quick Gasket
P/N. ACC-11001-05-01
Yamaha bond No. 1215
P/N. 90890-85505
14 Nm (1.4 m · kg, 10 ft · lb)
) 4 to the
®
®
)