Adjusting The Starter Cable - Yamaha Rhino 450 YXR45FAV Service Manual

ADJUSTING THE STARTER CABLE

1
3 - 8
ADJUSTING THE STARTER CABLE
1. Remove:
• driver seat
• passenger seat
• console
Refer to "SEATS, ENCLOSURE, HOOD
AND CARGO BED" in chapter 8.
2. Adjust:
• starter cable
M MMM M MMM M M MMM M M MMM M
a. Disconnect the starter cable 1 from the
carburetor body.
NOTE:
Do not remove the starter plunger 2 from the
starter cable.
b. Measure the starter plunger stroke distance
a of the starter (choke) knob 3 fully closed
to fully open position. If the distance is out
of specification, adjust it as described
below.
Starter plunger stroke distance
13 mm (0.51 in)
È Fully closed position
É Fully open position
c. Pull back the boot 4.
d. Loosen the locknut 5.
e. Turn the adjuster 6 in or out until the cor-
rect distance is obtained.
Turning in Distance increases.
Turning out Distance decreases.
f. Tighten the locknut 5.
g. Push in the boot 4.
h. Connect the starter cable to the carburetor.
L LLL L LLL L L LLL L L LLL L
3. Install:
• console
• passenger seat
• driver seat
Refer to "SEATS, ENCLOSURE, HOOD
AND CARGO BED" in chapter 8.
CHK
ADJ
M MMM M M MMM M MMM
L LLL L L LLL L LLL