Adjusting The Starter Cable; Checking The Spark Plug - Yamaha 5KM2-AE1 Service Manual

ADJUSTING THE STARTER CABLE/

CHECKING THE SPARK PLUG

3 - 21
ADJUSTING THE STARTER CABLE
1.Remove:
Seat
G
Fuel tank side panel (left)
G
2.Adjust:
*****************************************************
Adjustment steps:
Disconnect the starter cable 1 from the car-
G
buretor body.
NOTE:
Do not remove the starter plunger 2 from the
starter cable.
G
Measure the starter plunger stroke distance
a of the starter lever 3 fully close to fully
open position. If the distance is out of specifi-
cation adjust it as described below.
Starter plunger stroke distance:
15 mm (0.59 in)
È Fully closed position
É Fully open position
Pull back the boot 4.
G
Loosen the locknut 5.
G
Turn the adjuster 6 in or out until the correct
G
distance is obtained.
Turning in Distance increased.
Turning out Distance decreased.
Tighten the locknut 5.
G
Push in the boot 4.
G
G
Connect the starter cable to the carburetor.
WARNING
After adjusting the cable, turn the handle-
bar to right and left, and make sure that the
engine idling speed dose not increase.
*****************************************************
3.Install:
Fuel tank side panel (left)
G
Seat
G
CHK
ADJ