Transit And Delivery - Sharp MX-5500N Installation Manual

(2) Dust
If dust enters the machine, it may cause dirty copy and a paper
jam, resulting in a shortened lifetime.
(3) Direct rays of the sun
If the machine is installed under the rays of the sun, the exterior of
the machine may be discolored and abnormal copies may be pro-
duced.
(4) Gases and chemicals
Do not install the machine at a place where there are gases and
chemicals. Especially be careful to avoid installation near a diazo-
type copier, which produces ammonium gas.
Copy quality may be adversely affected and a trouble may be
caused.
(5) Vibration
Avoid installation near a machine which produces vibrations.
If vibrations are applied to the copier machine, copy images may be
deflected and a trouble may be caused.

2. Transit and delivery

No
1
2
A. Implements, facility, and manpower
It is recommendable to use a forklift for bringing in the machine for
safety.
If no forklift is available, Be sure to use the skid slope (DKIT-
0367FCZZ). Be careful to safety and pull the machine down. The
carrying in must ensure manpower of four persons or more for
safety. The machine is considerably heavy, and requires safety
precautions for delivery and installation.
Transit of the machine must be made in packed condition to the
installing place.
Since the hard disk drive is built in the machine, use care not to
exert vibrations or shocks to the machine when in transit.
B. Delivery
Remove the packing materials prior to installation in the office envi-
ronment.
3. Unpacking
A. Pulling out of the main unit
1)
MX-7000N MX-5500N/6200N/7000N 1 – 2
Content
Implements, facility, and
manpower
Delivery
Remove the top case, the top cushion, the packing case, and
the bundled item.
Method
Use a forklift. (If no forklift is
available, ensure manpower of four
persons or more, and use the skid
slope (DKIT-0367FCZZ)).
Transit must be made in packed
condition.