Sharp MX-5500N Installation Manual page 57

2) Check the height of rear cabinet of the inserter and rear cabi-
net of the finisher.
* When the height is properly adjusted, progress to the proce-
dure of "H. Check the clearance of the main unit and the
inserter".
When the height is not properly adjusted, progress to the fol-
lowing procedures.
<Adjust of the height on front side>
3) Remove each cabinet of the finisher, and loosen the front
caster fixing screws on the inserter side.
* The adjustment procedure is different according to the
installed finisher. For details, refer to the adjustment proce-
dure of each finisher.
4) Turn the height adjustment bolt so that the upper cabinet may
become equal height.
5) Tighten the caster fixing screws.
Rear
MX-7000N MX-CFX1 5 – 7
<Adjust of the height on rear side>
6) Remove the rear cabinet of the finisher, and loosen the rear
caster fixing screws on the inserter side.
7) Turn the height adjustment bolt so that the upper cabinet may
become equal height.
8) Tighten the caster fixing screws.