Sharp MX-5500N Installation Manual page 38

<2>
Turn the adjustment screw above to adjust the height.
After adjustment with the adjustment screw, tighten the screws
on the both ends of the caster movable plate which were loos-
ened in the previous procedure.
NOTE: Adjust so that the marks on the left and the right sides
of the caster movable plate and the lead edge of the triangular
hole are at the same height.
<3>
Check the height in procedure C-1). If the height is not proper,
go to <2>. If the height is proper, install the positioning plates
to the front and the rear sides and fix them with the fixing
screws B (1 pc. for each side).
Front side
Rear side
c. If the upper section of the LCC left side is locked first
and the positioning plate cannot be inserted :
<1>
Loosen the caster screw in the lower section of the LCC right
side.
<2>
Turn the adjuster to lower the LCC right side.
<3>
Tighten the caster screw.
Right side
Since the LCC may be moved by the paper weight
when closing the tray, the adjuster must be securely
on the floor.
<4>
Check the height in procedure 1). If the height is not proper,
separate the LCC (the procedure is described later) and go to
"b".
If the height is proper, install the positioning plates to the front
and the rear sides with fixing screws B.
MX-7000N MX-LCX3 3 – 6