Sharp MX-5500N Installation Manual page 40

[How to separate the LCC from the machine]
1) Remove the left front cabinet of the LCC.
2) Remove the positioning plate installed to the front and the rear
sides of the left lower side of the LCC.
Front side
Rear side
3) Raise the adjuster installed to the front and the rear sides of
the lower section of the LCC right side.
4) Push the resin cover beneath the lock section on the top of the
left side of the LCC and shift the LCC to the right. Release the
top lock.
5) Shift the LCC to the right to separate.
D. Connector connection
1) Remove the screw (one for each) from the connector covers
on the main unit and then remove the connector covers
(2pcs.).
2) Connect the large capacity tray interface harness connector
(a) and the heating heater interface harness connector (b) to
the main unit connector, and tighten the connector screw to fix
the connector.
MX-7000N MX-LCX3 3 – 8
a
b