Sharp MX-5500N Installation Manual page 70

3) Check that the center of the screw hole of the finisher is in the
range of specification of an oval hole of the connection fixture
that exist on main body rear side.
* When not the range of specification, execute the following
adjustment. If the adjustment is not required, progress to the
procedure of "E. Touch of the auxiliary caster with the floor".
D. Adjustment
1) Remove the finisher from the main unit.
2) Remove the screws, slide to the left the front lower cover, and
remove it.
3) Open the front upper door.
4) Remove the screws, and open the front lower door.
5) Remove the fixing tapes.
6) Remove the screws, and remeve the rear lower cover.
MX-7000N MX-FNX3 7 – 4