Sharp MX-5500N Installation Manual page 14

2) Install the IL interface harness (Package part No. 4).
3) Install the switch cover and fix it with a screw.
(3) Installation of the paper exit tray
1) Remove the resin E ring, and remove the toner cover.
* Even if the toner cover remains being installed, the following
procedure is possible. However, remove it for the working
property.
2)
3)
(4) Installation of the paper holding arm and paper
1)
MX-7000N MX-5500N/6200N/7000N 1 – 11
Install the paper exit tray (Package part No. 1) to the main unit,
and fix with the screws (Package part No. 5).
Install the toner cover and fix it with a resin E ring.
exit full detection actuator
Install the paper holding arm (Package part No. 2), and install
the paper exit full detection actuator (Package part No. 3).
* Check the size of the diameter of place where paper holding
arm is installed.
6
4