Sharp MX-5500N Installation Manual page 29

2) Loosen the stopper fixing screw (1 pc.) on the lower right side
of the paper feed tray to disable the stopper function.
3) Then pull out the paper feed tray again until it stops.
a. Side plate size switch
1) Remove the four fixing screws (blue) which are fixing the
upper and the lower sections of the side plate F and the side
plate R.
F side
2) Then fit the paper feed tray on the lower side of the side plate
F and the side plate R with the engraved marks of the side
plates according to the size, and insert it. Also fit the upper
side to the size and fix it with the four fixing screws (blue) that
have been removed in step 1).
b. Auxiliary guide size switch
1) When changing the size of the side plate R, check to confirm
the mark positions of "
guide adjustment plate.
2) Loosen the fixing screw (flat screw 1pc.) of the auxiliary guide.
3) Change the mark position (
cassette R from A4 to LT, and fix them with the fixing screw
(flat screw, 1pc.).
R side
At that time, adjust so that the mark positions (
auxiliary guide and the cassette R are at the same positions of
the mark positions (
adjustment plate checked in the procedure 1).
(If the scale of the size guide adjustment plate is at the center,
set it to the center. If the size guide adjustment plate is in 1mm
in the front side, set it in 1mm in the front side.)
c. Rear edge shaft switch
1) Remove the rear edge shaft fixing screw (blue) on the right
side of the paper feed tray, and remove the rear edge shaft.
MX-7000N MX-LCX2 2 – 6
F side
" on the side plate R and the size
) of the auxiliary guide and the
A4 LT
) of the side plate R and the size guide
R side
) on the