Sharp MX-5500N Installation Manual page 92

* If the fax box unit is installed, carry out the steps 3).
3) Connect the I/F cable to the MFP PWB. Push the I/F cable into
the recessed portion of the sheet metal on the control box.
Attach the snap band to sheet metal of the control box.
*Check that the connector is not obliquely inserted.
3
4) Push the control box into the main unit. Lay the finger handle.
Fix with the screws.
1
5) Push into the cable to the right cabinet rear cover, and attach
it. At this time, check that the pawls are properly fitted to the
main unit.
5
4
* Reconnect the cables that have been removed in step B to the
original positions of the control box.
2
1
3
2
2
2
3
3
1
2
MX-7000N AR-PF1 11 – 3
E. Turn ON the main power switch of the main
unit
1) Insert the power plug of the main unit into the power outlet.
2) Open the front cabinet, and turn ON the power switch.
3) Turn ON the power switch on the operation panel.
F. PCL expansion font list check
1) PCL expansion font list check.
Select the PCL expansion font list by the procedures described
in the printer test page in the system setup guide.
Check to confirm that the barcode font list is printed.
"ON"
ON
ON