Rack - Mounting And Dismounting; Specifications For The Rack - Fujitsu Celsius C620 Operation Manual

Rack - mounting and dismounting

Instructions for rack mounting are given below.
The manuals for the rack cabinet contain detailed information on other mounting systems.
i
Due to its weight and external dimensions, for safety reasons at least two persons are
!
required to install the device in a rack.
Do NOT use the QRLs (Quick Release Levers) on the front panel to lift the device into the
rack.
When connecting and disconnection the cables, also follow the instructions in the
"Important Information" section of the operating manual for the particular rack. The
operating manual is supplied together with the rack when it is delivered.
When installing the rack, make sure that the anti-tilt bracket is properly fitted.
For safety reasons, a maximum of one unit may be pulled out of the rack during assembly
or service work.
If several units are pulled out of the rack simultaneously, there is a danger of the rack
tipping over.
The mains connection of the rack must be carried out by an authorised professional
(electrician).
If the device is incorporated into an installation supplied with power by an industrial supply
network with a Type IEC 309 connection plug, the fusing of the power supply network must
meet the requirements for non-industrial power supply networks for plug type A.

Specifications for the rack

The Fujitsu rack systems PRIMECENTER Rack, DataCenter Rack and 19 inch standard rack (for
Japan) support the installation of devices.
Installation in the currently popular rack systems from various third party manufacturers (3rd party
racks) is supported for the most part.
In order to satisfy the ventilation concept and provide sufficient air to the devices, all the unoccupied
areas in the rack must be closed off with dummy covers.
The power connection is made using the existing power strips in the particular rack.
Fujitsu Technology Solutions
Rack - mounting and dismounting
23