Removing And Installing Non-Accessible Drives (Hard Disks, Hdd/Ssd); Removing And Installing Non-Accessible 2½ Inch Drives (Hard Disks, Hdd/Ssd) - Fujitsu Celsius C620 Operation Manual

Removing and installing non-accessible drives (hard
disks, HDD/SSD)
CAUTION!
!
•
Removal of a hard disk drive or solid state drive from the installation frame must only
be performed by a service technician.
•
The HDD/SSD modules (drives) must all be uniquely labelled so that they can be put
back in their original locations after an upgrade. If you do not do this, existing data
can be destroyed.
•
The device does not support any hot-plug functions. Always shut down the device to
change drives. See section "Shutting down the device".
You can find further information on RAID configuration and/or the RAID level in the
documentation for the RAID controller.
•
Circuitry on boards or soldered components must not be touched. Hold the boards by
their edges or metallic areas.
•
Before you remove a unit, wait for about 30 seconds until the data carrier has come
to a complete standstill.
•
During start-up, drives may briefly cause the device to resonate, producing a buzzing
noise. This does not mean that there is a fault however. As soon as the drives have
reached their normal speed, the buzzing noise stops.
•
Depending on the operating system, you may configure any write cache settings for
the hard disk drive. Should a power failure occur with an active write cache, data
could be lost.
•
If you dispose of a hard disk drive or solid state drive, deliver it to a third party or wish
to return it, for your own security you should destroy any data saved on the drive.
•
Rough handling of hard disk drives can cause damage to the saved data. Before you
attempt to resolve unexpected problems, always make a backup copy of important
data. When backing up data onto another hard disk drive, you should proceed by
each file or partition.
•
Take care that the hard disk drive is not subjected to any impacts and that it does not
come into contact with any metal objects.
•
Use the device on a shock-free and vibration-free surface.
•
Do not use the device in very hot or very cold locations, nor where there are extreme
changes in temperature.
•
Never try to dismantle a hard disk drive or a solid state drive.
Removing and installing non-accessible 2½ inch drives (hard
disks, HDD/SSD)
A maximum of four non-accessible 2½ inch SAS/SATA HDD/SSD modules can be installed. Each
HDD/SSD module can accept a SAS/SATA hard disk drive or a SATA solid state drive in 2.5 inch
format. The connection of the HDD/SSD modules to the SAS/SATA backplane is wire-free. This
allows the HDD/SSD modules to be simply plugged in or pulled out.
Fujitsu Technology Solutions
System expansion
61