Using Dhcp/Bootp; Figure 4-6 Ipv4 Interface Configuration - Dhcp - Edge-Core ES4626F Management Manual

24/48-port stackable layer 3 gigabit ethernet switch

Hide thumbs Also See for ES4626F:

Table of Contents

Basic Management Tasks

Using DHCP/BOOTP

If your network provides DHCP/BOOTP services, you can configure the stack to be

dynamically configured by these services.

Web – Click IP, General, Routing Interface. Specify the VLAN to which the

management station is attached, set the IP Address Mode to DHCP or BOOTP. Click

Apply to save your changes. Then click Restart DHCP to immediately request a new

address. Note that the stack will also broadcast a request for IP configuration

settings on each power reset.

If you lose your management connection, make a console connection to the

Master unit and enter "show ip interface" to determine the new stack address.

CLI – Specify the management interface, and set the IP address mode to DHCP or

BOOTP, and then enter the "ip dhcp restart client" command.

Console#config

Console(config)#interface vlan 1

Console(config-if)#ip address dhcp

Console(config-if)#end

Console#ip dhcp restart client

Console#show ip interface

Vlan 1 is up, addressing mode is DHCP

Interface address is 192.168.1.253, mask is 255.255.255.0, Primary

MTU is 1500 bytes

Proxy ARP is disabled

Split horizon is enabled