Setting The Switch's Ip Address (Ip Version 4); Figure 4-3 Displaying Bridge Extension Configuration - Edge-Core ES4626F Management Manual

24/48-port stackable layer 3 gigabit ethernet switch

Hide thumbs Also See for ES4626F:

Table of Contents

Web – Click System, Bridge Extension.

CLI – Enter the following command.

Console#show bridge-ext

Max support VLAN numbers:

Max support VLAN ID:

Extended multicast filtering services: No

Static entry individual port:

VLAN learning:

Configurable PVID tagging:

Local VLAN capable:

Traffic classes:

Global GVRP status:

Setting the Switch's IP Address (IP Version 4)

This section describes how to configure an initial IPv4 interface for management

access over the network. This switch supports both IPv4 and IPv6, and can be

managed through either of these address types. For information on configuring the

switch with an IPv6 address, see "Setting the Switch's IP Address (IP Version 6)" on

The IPv4 address for this stack is obtained via DHCP by default. To manually

configure an address, you need to change the stack's default settings to values that

are compatible with your network. You may also need to a establish a default

gateway between the stack and management stations that exist on another network

segment (if routing is not enabled on this stack).

You can manually configure a specific IP address, or direct the device to obtain an

address from a BOOTP or DHCP server. Valid IP addresses consist of four decimal

Setting the Switch's IP Address (IP Version 4)