Dynamic Configuration - Edge-Core ES4626F Management Manual

24/48-port stackable layer 3 gigabit ethernet switch
Hide thumbs Also See for ES4626F:
Table of Contents

Advertisement

Dynamic Configuration

Obtaining an IPv4 Address
If you select the "bootp" or "dhcp" option, IP will be enabled but will not function until
a BOOTP or DHCP reply has been received. Requests will be sent periodically in an
effort to obtain IP configuration information. BOOTP and DHCP values can include
the IP address, subnet mask, and default gateway. If the DHCP/BOOTP server is
slow to respond, you may need to use the "ip dhcp restart client" command to
re-start broadcasting service requests.
If the "bootp" or "dhcp" option is saved to the startup-config file (step 6), then the
switch will start broadcasting service requests as soon as it is powered on.
To automatically configure the switch by communicating with BOOTP or DHCP
address allocation servers on the network, complete the following steps:
1.
From the Global Configuration mode prompt, type "interface vlan 1" to access
the interface-configuration mode. Press <Enter>.
2.
At the interface-configuration mode prompt, use one of the following commands:
• To obtain IP settings via DHCP, type "ip address dhcp" and press <Enter>.
• To obtain IP settings via BOOTP, type "ip address bootp" and press <Enter>.
3.
Type "end" to return to the Privileged Exec mode. Press <Enter>.
4.
Type "ip dhcp restart client" to begin broadcasting service requests.
Press <Enter>.
5.
Wait a few minutes, and then check the IP configuration settings by typing the
"show ip interface" command. Press <Enter>.
6.
Then save your configuration changes by typing "copy running-config
startup-config." Enter the startup file name and press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ip address dhcp
Console(config-if)#end
Console#ip dhcp restart client
Console#show ip interface
IP address and netmask: 192.168.1.54 255.255.255.0 on VLAN 1,
and address mode: DHCP
Console#copy running-config startup-config
Startup configuration file name []: startup
\Write to FLASH Programming.
\Write to FLASH finish.
Success.
Basic Configuration
27-1
41-3
39-2
41-5
23-11
2
2-11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Es4650f

Table of Contents