Network; Neighbor - Edge-Core ES4626F Management Manual

network

This command specifies the network interfaces that will be included in the RIP
routing process. Use the no form to remove an entry.
Syntax
[no] network subnet-address
subnet-address – IP address of a network directly connected to this router.
Command Mode
Router Configuration
Default Setting
No networks are specified.
Command Usage
• RIP only sends updates to interfaces specified by this command.
• Subnet addresses are interpreted as class A, B or C, based on the first field
in the specified address. In other words, if a subnet address nnn.xxx.xxx.xxx
is entered, the first field (nnn) determines the class:
0 - 127 is class A, and only the first field in the network address is used.
128 - 191 is class B, and the first two fields in the network address are used.
192 - 223 is class C, and the first three fields in the network address are used.
Example
This example includes network interface 10.1.0.0 in the RIP routing process.
Console(config-router)#network 10.1.0.0
Console(config-router)#
Related Commands
router rip (42-6)

neighbor

This command defines a neighboring router with which this router will exchange
routing information. Use the no form to remove an entry.
Syntax
[no] neighbor ip-address
ip-address - IP address to map to a specified hardware address.
Command Mode
Router Configuration
Default Setting
No neighbors are defined.
Routing Information Protocol (RIP)
42
42-9