Table of Contents
Advertisement
Redistributing Routing Information from Other Domains
RIP can be configured to import external routing information from other routing
domains (that is, protocols or static routes) into the autonomous system.
Command Attributes
• Redistribute Protocol – Only static routes can be imported into this routing
domain.
• Redistribute Metric – Metric value assigned to all external routes for the specified
protocol. (Range: 1-15; Default: The default metric value is set by the
default-metric command described on page 42-7).
If a redistribution metric has not been configured for static routes, the
default-metric command (page 42-7) sets the metric value to be used for all
imported external routes.
A route metric must be used to resolve the problem of redistributing external routes
with incompatible metrics.
It is advisable to use a low metric when redistributing routes from another protocol
into RIP. Using a high metric limits the usefulness of external routes redistributed
into RIP. For example, if a metric of 10 is defined for redistributed routes, these
routes can only be advertised to routers up to 5 hops away, at which point the
metric exceeds the maximum hop count of 15. By defining a low metric of 1, traffic
can follow a imported route the maximum number of hops allowed within a RIP
domain. However, using a low metric can increase the possibility of routing loops
For example, this can occur if there are multiple redistribution points and the router
learns about the same external network with a better metric from a redistribution
point other than that derived from the original source.
Configuring the Routing Information Protocol
20
20-9
Advertisement
Table of Contents
