Display Electronic Board And Dashboard Electronic Board Replacement - Clarke Focus II Micro Rider 26D Service Manual

DISPLAY ELECTRONIC BOARD AND DASHBOARD ELECTRONIC BOARD REPLACEMENT

Display electronic board disassembly
1. Drive the machine on a level floor.
2. Turn the ignition key to "0" and disconnect the batteries.
3. Remove the steering wheel height control lever (A).
4. Lift the cover (B) and remove the seeger (C), then remove the steering wheel assembly (D).
5. Lift the covers and unscrew the screws (E), then lift the dashboard assembly (F).
6. Disconnect the connector (G) from the ignition key and the connector (H) from the electronic board.
7. Disconnect the flat connectors (I) of the dashboard electronic board.
8. Unscrew the nuts (J), recover the spacers and remove the display electronic board (K).
Dashboard electronic board disassembly
9. Perform steps 1 to 7 of the display electronic board disassembly.
10. Remove the ignition key (L).
11. Remove the bush (M).
12. Carefully lift and remove the dashboard electronic board (N) from the plate (F).
Assembly
13. Assemble the components in the reverse order of disassembly, and note the following:
• Install the dashboard electronic board (N) by passing the flat connectors (I) into the slots of the plate (F), then carefully
install it on the plate.
Service Manual -
E
M
F
I
G
H
FOCUS II Micro Rider
L
D
B
A
C
E
N
K
J
ENGLISH
ELECTRICAL SYSTEM
59
P100504