Drive System Motor Carbon Brush Check/Replacement - Clarke Focus II Micro Rider 26D Service Manual

ENGLISH
DRIVE SYSTEM

DRIVE SYSTEM MOTOR CARBON BRUSH CHECK/REPLACEMENT

Check and replacement
1. Drive the machine on a level floor.
2. Turn the ignition key to "0" and disconnect the batteries.
3. Remove the electromagnetic brake (see the procedure in the electromagnetic brake disassembly/assembly paragraph).
4. Remove the drive system motor (see the procedure in the following paragraph).
5. At the workbench, with indelible pen mark the installation position of the flange on the drive system motor (A).
6. Remove the screws (B), the flange (C) and the plastic ring (D).
7. Disengage the thrust spring (E) and remove the 2 carbon brushes (F).
8. Check the carbon brushes for wear.
The carbon brushes are worn when the contact with the motor armature is insufficient, the contact surface is not even, the
thrust spring is broken, etc.
If necessary, replace the carbon brushes.
Reset
9. Assemble the components in the reverse order of disassembly, and note the following:
• Clean (with compressed air) the area around the carbon brushes and the removed components.
• Assemble the carbon brushes (F) with the cables (G) positioned as shown in the figure.
• Install the flange (C) on the drive system motor using the mark (A) as reference.
B
G
F
46
A
B
F
Service Manual -
C
D
E
FOCUS II Micro Rider
P100495