Boost ® Deck Motor Disassembly/Assembly (For Focus Ii Micro Rider 28 Boost) - Clarke Focus II Micro Rider 26D Service Manual

BOOST DECK MOTOR DISASSEMBLY/ASSEMBLY (For FOCUS II Micro Rider 28 BOOST)
®
Disassembly
1. Remove the BOOST
®
2. At the workbench, remove the screw (A), recover the washer and remove the locking eccentric disc (B).
3. Remove the screws (C), recover the washers and lift the motor holder assembly (D).
4. Recover the spacer (E) and the key (F).
5. Remove the screws (G), then remove the motor (H).
6. Recover the connector holder (I).
Assembly
7. Assemble the components in the reverse order of disassembly, and note the following:
• Install the motor rotated as shown in the figure.
• Tighten the screws (G) at 14.7 lbf/ft (20 N/m, 2.0 kgf/m).
• When tightening the screws (C) and (A), apply Loctite on threads.
• When tightening the screw (A), use an impact driver.
NOTE
For further information on deck components see the Spare Parts List.
Service Manual -
deck from the machine (see the procedure in the
C
D
C
G
E
FOCUS II Micro Rider
BOOST deck disassembly/assembly
I
C
C
G
B
A
ENGLISH
SCRUB SYSTEM
paragraph).
H
F
P100481
27