Squeegee Lifting Cable Disassembly/Assembly - Clarke Focus II Micro Rider 26D Service Manual

SQUEEGEE LIFTING CABLE DISASSEMBLY/ASSEMBLY

Disassembly
1. Remove the squeegee lifting assembly (see the previous paragraph, steps 1 to 6).
2. At the workbench, remove the screw (A) and recover the nut.
3. Carefully remove the squeegee lifting cable (B) from the pulleys.
Assembly
4. Install the lifting cable and note the following:
• Apply AGIP GR 30 grease or equivalent on the entire length of the cable.
• Insert the cable in the direction shown by the arrow (C).
• Route the cable in the pulleys (D), (E) and (F) in sequence.
• Fasten the cable grommet with the screw (A) and nut.
5. The components must be carefully installed as shown in the figure for the proper operation of the lifting system.
6. Install the squeegee lifting assembly (see the previous paragraph).
7. Check the proper operation of the squeegee lifting system.
NOTE
The squeegee lifting system pulleys are self-lubricating and do not require maintenance.
D
B
A
Front
Service Manual -
F
E
FOCUS II Micro Rider
RECOVERY WATER SYSTEM
D
E
C
ENGLISH
F
A
Front
P100491
39