Motor & Esc Installation - GREAT PLANES Riot 3D Instruction Manual

❏
17. Insert a Z-bend clevis (A1) into four closed ended
hinge points (C4) as shown.
❏
18. Cut a slot in the aileron and insert the closed ended
hinge points (C4) with the Z-bend clevis (A1) facing the
fuselage as shown. Glue in place with CA.
❏
19. Insert a 6" [153mm] carbon pushrod between the
Z-bend clevises (A1). Align both ailerons at neutral and glue
the carbon pushrod in place. Trim the carbon rod as needed.
Be careful as you get only one chance for proper
alignment before the glue sets.
Motor & ESC Installation
❏
1. The power system recommended for the Riot 3D ARF is
the ElectriFly RimFire ™
APC Slo-Flyer prop, and Silver Series SS-8 Amp ESC. This is
the power system that will be illustrated in the manual. If you
choose another power system for your Riot 3D ARF, use the
manual as a general guide for your installation.
❏
2. Attach the motor to the firewall as shown using three
#2 x 1/8" [3.2mm] screws and #2 washers. Remove the
screws and harden the mounting holes by applying thin CA.
Reinstall the #2 x 1/8" [3.2mm] screws and #2 washers. Drill
a 3/8" [9.5mm] hole in the lower right corner of the firewall
as shown for routing the motor leads.
11
28-22-1380kV out-runner motor, 8x3.8