GREAT PLANES Riot 3D Instruction Manual page 10

❏ ❏
9. Drill a 3/32" [2.4mm] hole and glue the pushrod
standoff (E3) in place as shown.
❏ ❏
10. Align the rudder at neutral with the servo arm
centered. Apply a small drop of thin CA where the pushrod
enters each clevis.
❏ ❏
11. Repeat steps 1-10 for the elevator pushrod. Final
installation should resemble the photo above.
❏
12. Glue a servo in place in the bottom wing as shown.
❏
13. Install two Z-bend clevises (A1) into the outer holes on
the double servo arm (G4).
❏
14. Attach a double servo arm (G4) that fits your servo.
Enlarge the outer holes in the double servo arm (G4) before
installing the arm on the servo.
❏
15. Install Z-bend clevises (A1) into two control horns
(B1) and glue them in place as shown. Press a backplate
(B2) onto the back side of the control horn (B1). The Z-bend
clevises (A1) should be installed on the outer side of the
control horn (B1).
❏
16. Locate the two 6" [153mm] carbon pushrods. Insert
the pushrod into the Z-bend clevises (A1) as shown. Using
your radio, center the servos and align the ailerons at
neutral. Adjust the pushrods as needed. Secure in place with
a drop of thin CA where the pushrods enter the Z-bend
clevises (A1).
10